No translation slot for the internal host has been configured.
Verify that a translation slot (xlate) exists for the internal host.
Examine the syslog output for message IDs 305005 and 305006 to determine the interface name that the packet came in on and the interface the packet for which the packet is destined. Then, check the config and verify the following.
The host's address is contained within one of the nat statements on that interface, and there is a corresponding global statement on the destination interface.
A static statement exists for that host between the two interfaces.
The source and destination address is contained within an access list that is applied to the nat (interface) 0 access-list xxx command.
Hi All, Can some advise on the design strategy for large scale deployment. We are trying to deploy a 28-30 node deployment with individual nodes in DC and DR and some dedicated local PSNs as VM in critical sites so that local user authenti...
Hello,I have a question regarding HA setup within a LAN, in a scenario where there are 2 main buildings. I'm curious as to how this would be best achieved through either configuration or from a design standpoint. I have attached an image showing the setup...
Hi,Good day I was trying to set-up Cisco ESA C390 in one our data center but I'm having issues establishing connections to external and public mail servers. Below is the error when I tested SMTP ping via CLI: Starting SMTP test of host alt1.gmai...
Hi All I would like to know if the firepower 4100 setup in Active-Passive, so if the uplink switch in VSS, combine 2x 40G uplink to the Firepower pair. QuesionFirepower Active-Passive setup, what would the real time interface bandwidth would be ...