The issue is seen with CiscoSecure ACS Solution Engine 3.3.3 and is documented in Cisco bug ID CSCsc03778.
If a change is made in the Access Policy, under Administration Control on the CiscoSecure ACS Solution Engine, and then replicated to another CiscoSecure ACS Solution Engine, the changes are not enforced on the receiving CiscoSecure ACS appliance until it is rebooted.
Access Policy changes do not immediately take effect on the secondary CiscoSecure ACS Solution Engine after database replication completes. However, the replicated changes do appear in the GUI.
This only occurs with changes made under Administration Control > Access Policy, and it only impacts the secondary replication server.
In order to resolve this issue, complete one of these actions:
Press Submit on the Access Policy page.
Stop or start the CSAdmin.
Do this through the console for an appliance, or through Windows Administrator for the software version.
Hello. I have a FPR2110-NGFW-K9 that is running cisco-asa-fp2k.126.96.36.199.SPA however I have not yet installed the ASA application. The box is currently just running the fxos lfbff:
I am trying to access the Firepower Chassis Manager GUI. I hav...
Hi We have cisco switch. In order to access these switch (it may be old switch or old CRT) via ssh, some cipher need to change. Can we change these cipher via the command below to add or delete any of there cipher? the command is like below. I tried...
Hi All, I have configured RA VPN with anyconnect on my Cisco FDM. Whenever I connect to VPN, I have no internet access. What is missing?I also have another question. How can I relate a user to a specific group policy. for example I want user A to hav...
I have been attempting to set up user monitoring on our Cisco Firepower device so we can see usernames instead of IP addresses under monitoring. It works with the VPN connection but not for internal traffic. What could I be overlooking or does this requir...
My SNS-3615 is running ISE 3.1 patch-3 with FIPs mode DISABLED; --> Administration --> System --> Settings --> FIPs mode disabled. However, from the ISE 3.1 patch-3 server, whenever I ssh into my external CentOS-7 Linux server, that...