The Sensor (idsm2, nm-cids, 4215) lock up occurs so that you cannot log into the Cisco Admin account. Sometimes you cannot log into the service account either.
This issue occurs when the hard disk drive (HDD) for these platforms is not allowed to spin down at least once a day. When the HDD is continually used for long periods of time (weeks), the HDD heads become out of sync. This Sensor eventually reaches a lock up state that does not allow you to login. Sometimes there are HDD I/O errors in the Sensor logs.
For a workaround:
Power off the Sensor from which the IDSM2 blade must be pulled from the switch for 20 minutes and then power it on again.
Download and upgrade the IDS software to version 5.0(6), 5.1(2) or later for a permanent solution.
Note: If the software used is 5.0(6) or later, the sEventStore/WerrWarning Event store circular buffer may be in an invalid state, recoveringerror message is also found in the Show tech or cidDump on the Cisco IDS, which occurs because of database index rebuild.
Cannot communicate with authenticationApp (getUserAccountConfig). Please contact your system administrator
We currently operate a "Tunnel All" policy for vpn traffic due to conditional access of hosted applications (Traffic must come from the head Office IP). What were finding with the increase in remote workers with fast home connections is there saturat...
Dear all. is there any way to send email to quarantine if email was not being verified by Envelop Sender DNS verification? User complained that he didn't get email from xxx.com domain. when I looked at logs observed that domain was not verified by dn...
The customs have asked for the following any assistance on how I can provide this would be appreciated. Please could you provide evidence the devices you are exporting have not got the standard encryption functionality indicated in the technical spec...
Dear All,We have two ASA 5580 in fail-over mode. Our users connects to VPN using Anyconnect.This VPN login is authenticated from AD (For domain users: who logs in to domain) But there are such users in AD who does not log into AD but uses VPN t...
Hello, I have anyconnect VPN and I would like to set up a profile that performs authentication with AD credentials and machine certificate.With AD credentials I am ok.I am not sure about the certificate. How can I use the machine certific...