This topic is a chance to discuss more about the best deployment and troubleshooting practices for Cisco Anyconnect. This session focuses on solving all queries related to Anyconnect from installation and licensing issues to its deployment issues and best troubleshooting practices, it covers booth SSL and IKEv2. AnyConnect empower employees to work from anywhere, it simplifies secure endpoint access and provides the security necessary to help keep organization safe and protected.
Ask questions from Monday 20th of November to Friday 8th of December, 2017
Aditya Ganjoois a Customer Support Engineer in the Cisco High-Touch Technical Services (HTTS) team based in Bangalore, India.He has been working with TAC from past 6 years in Security domains like Firewall, VPN and AAA. Aditya has delivered trainings on ASA and VPN technologies. Aditya holds a Bachelor's degree in Information Technology.He has achieved certifications for CCNA, CCNA-Security and is currently pursuing CCIE Security.He has been a consistent contributor on Cisco Support Community.
Puneesh Chhabra is a Customer Support Engineer in the Cisco High-Touch Technical Services (HTTS) team based in Bangalore, India. He has total of 9 years of experience in network security. He has delivered multiple trainings on Cisco firewalls and VPN solutions. Prior to joining Cisco, he worked at IBM and HCL as network security consultant. Chhabra holds bachelor of Science degree in Computer Sciences from Kurukshetra University. He has achieved his CCIE certification in Security. (CCIE Security #30128)
Aditya and Puneesh might not be able to answer each question due to the volume expected during this event. Remember that you can continue the conversation on the Contact Center Community
Hi Guys, just want to double check with you. In FTD, I have 2 subnet and if I need to have intervlan for those 2 VLAN, do I still need to configure an identity NAT or any NAT?My target is doing intervlan routing between the 2 VLAN without any IP change.th...
Hi,I set up DVTI in EVE with 2 routers. HUB------SPOKE.Virtual-template is not showing up/down. Instead of up/up.Checked Phase1 and Phase2 parameters but not sure where I made a mistake.Attached diagram and configuration.Please take a look.
I tested using both Cisco ISE 2.4 (patch 9) and Cisco ISE 2.6 (patch 1). I have a user who successfully authenticated via RADIUS against ISE. Under ISE, Operations > Live Logs (and Live sessions), I see the user authenticated. After the accounting requ...