This topic is a chance to discuss more about the best configuration and troubleshooting practices for security features on Cisco Adaptive Security Appliances (ASA). This session provides an opportunity to learn and ask questions about the functionality of Cisco ASA, starting from hardware to software level details. The topic will cover ASA architecture, NAT, ACL and high memory, high CPU issues on an ASA. Also, issues related to attack prevention mechanisms and deep packet inspection for layer 7 protocols will be addressed.
Ask questions from Monday 19th of February to Friday 2nd of March, 2018
Dinesh Moudgil is a High Touch Technical Support(HTTS) Engineer with Security team in Cisco at Bangalore, India, he has been working on Cisco technologies for the past 5 years focusing on Cisco Next Generation Firewalls, Intrusion Prevention Systems, Identity Management and Access Control(AAA) and VPNs. Dinesh holds a Bachelor’s degree in Electronics & Communication with honours from Panjab University. Holding certifications from Cisco (CCNA & CCNP) and multiple vendors like Palo Alto (ACE and PCNSE), he has delivered multiple training and boot camps. He has been a consistent contributor on Cisco Support Community and has been awarded twice as one of the top contributors worldwide.
Pulkit Saxena works as High Touch Technical Support(HTTS) Engineer in Security Domain with Cisco, he has almost 6 years of experince in the industry. Pulkit graduated with a Bachelor’s degree in Electrical Engineering, and was recruited by HCL Technologies which helped him found his interest in networking. His area of expertise includes security domain and holds certifications from multiple vendors, namely Cisco and Juniper, (CCNA and JNCIA). He has hands on experience on multiple firewalls, different VPN solutions, AAA and Next Generation IPS and has also delivered multiple trainings. He holds strong conceptual knowledge on various security technologies including but not limited to Cisco Next Generation Firewalls, Intrusion Prevention Systems, Identity Management and Access Control. Apart from troubleshooting network problems, he enjoys working product support ability along with Cisco's Engineering teams.
Dinesh & Pulkit might not be able to answer each question due to the volume expected during this event. Remember that you can continue the conversation on the Contact Center Community
Good afternoon, I am after a bit of help regarding a Remote Access solution we are designing to allow Engineers to manage and configure our network devices via SSH/HTTPs through a RA VPN via our Internet Edge. We have a dedicated VPN firewall Ci...
Hi, ISE noob here. We have an issue where our 3rd party installer has essentially forgotten the ISE admin password and our backups have stuck in an inactive state. Long story short we are doing a password reset/recovery on the system but would like a reco...
Hello, I have access to WSA CLI and I am searcing any possible deny of traffic based on a specific source IP address: 1. "access_logs" Type: "Access Logs" Retrieval: FTP Poll Do you want this search to be case insensitive? [Y]>Do you wan...
Hello, I have a pair of FTD 2110 in HA. The authentication is through ARUBA and DUO. The problem I have is this. I logon to the VPN and then I have to press accept from the mobile. If I do not accept immediately then Anyconnect disconnects...
Hello All, i am using Amp connector version as : 220.127.116.1123 and operating system : windows 10 , where i am seeing some events as below on few machines , what actually it was referring to and how to resolve it