Welcome to the Cisco Support Community Ask the Expert conversation. This is an opportunity to learn and ask questions about how to deploy and configure Cisco Identity Services Engine (ISE) Version 1.2 and to understand the features and enhanced troubleshooting options available in this version, with Cisco expert Craig Hyps.
October 27, 2014 through November 7, 2014.
The Cisco Identity Services Engine (ISE) helps IT professionals meet enterprise mobility challenges and secure the evolving network across the entire attack continuum. Cisco ISE is a security policy management platform that identifies users and devices using RADIUS, 802.1X, MAB, and Web Authentication methods and automates secure access controls such as ACLs, VLAN assignment, and Security Group Tags (SGTs) to enforce role-based access to networks and network resources. Cisco ISE delivers superior user and device visibility through profiling, posture and mobile device management (MDM) compliance validation, and it shares vital contextual data with integrated ecosystem partner solutions using Cisco Platform Exchange Grid (pxGrid) technology to accelerate the identification, mitigation, and remediation of threats.
Craig Hyps is a senior Technical Marketing Engineer for Cisco's Security Business Group with over 25 years networking and security experience. Craig is defining Cisco's next generation Identity Services Engine, ISE, and concurrently serves as the Product Owner for ISE Performance and Scale focused on the requirements of the largest ISE deployments.
Previously Craig has held senior positions as a customer Consulting Engineer, Systems Engineer and product trainer. He joined Cisco in 1997 and has extensive experience with Cisco's security portfolio. Craig holds a Bachelor's degree from Dartmouth College and certifications that include CISSP, CCSP, and CCSI.
Remember to use the rating system to let Craig know if you have received an adequate response.
Because of the volume expected during this event, Ali might not be able to answer each question. Remember that you can continue the conversation on the Security community, sub-community shortly after the event. This event lasts through November 7, 2014. Visit this forum often to view responses to your questions and the questions of other community members.
Upon boot the LED indicator for WiFi on this ASA-5506W cycles through blinking green to blinking red. The documentation says it means "Ethernet link not operational". Since this is a hardware addon, I assume ethernet link is hard wired inside. To make sur...
I'm messing around in lab and trying to get the FTDv to do jumbo frames. According to the documentation its pretty simple but I've not had any luck. I set the MTU on the Interface to 9000 and FMC said it was enabling jumbo frames and to reboot...
Hi All, Can some advise on the design strategy for large scale deployment. We are trying to deploy a 28-30 node deployment with individual nodes in DC and DR and some dedicated local PSNs as VM in critical sites so that local user authenti...
Hello,I have a question regarding HA setup within a LAN, in a scenario where there are 2 main buildings. I'm curious as to how this would be best achieved through either configuration or from a design standpoint. I have attached an image showing the setup...
Hi,Good day I was trying to set-up Cisco ESA C390 in one our data center but I'm having issues establishing connections to external and public mail servers. Below is the error when I tested SMTP ping via CLI: Starting SMTP test of host alt1.gmai...