This is an opportunity to learn and ask more questions about Cisco Trustsec solution. The Trustsec solution is designed to flatten the network regardless of the access method but still provide fully distributed and differentiated access control no matter whether you are coming from wired or WiFi or remote access, the Trustsec solution provides a consistent access control policy.
Ankur Bajaj is a customer support engineer from the AAA team at the Cisco Technical Assistance Center in Richardson, Texas, USA. He has 14 years of total experience. He has worked on a wide range of Cisco Security Technologies such as Cisco ASA, VPN deployments, NAC solution, ACS and ISE deployment. Ankur has CCIE # 22135 in Security.
Mrinal Jaiswal has been with Cisco since 2007 with previous experience as a software developer. He works with AAA and Wireless Technical Assistance. Mrinal holds a CCIE in security #31389, MCSA in 2003 track, MCAD in .net, GNIIT from NIIT.
Beau Wallace is an engineer for the RTP AAA TAC team, supporting multiple solutions including ISE, TrustSec, 802.1x, ACS, NAC, etc. He attended East Carolina University and lives in Raleigh, NC. He holds CCNP, RHCSA, and Security+ Certifications
This Discussion starts Dec 16th through Dec 19th, 2014
Remember to use the rating system to let the exerts know if you have received an adequate response.
The experts might not be able to answer each question due to the volume expected during this event. Remember that you can continue the conversation in Security community, sub-community, AAA, Identity and NAC discussion forum shortly after the event. This event lasts through December 19, 2014. Visit this forum often to view responses to your questions and the questions of other community members.
I have 2 new FPR-1010 According to the documentation, on the first boot, I should get a EULA prompt and then a "Manage the device locally? (yes/no) [yes]: no"https://www.cisco.com/c/en/us/td/docs/security/firepower/quick_start/fp1010/firepower-1010-g...
We have two Data Centers, East and West. The West is considered our DR site (separate, but identical Hw). If the EDC data center craters, we would like to spin up the WDC using the EDC's Master System config.Currently we are using a tool to pu...
Hello, In our customer environment, the Node status of the secondary ISE node is showing up as "Replication Stopped".By logging into the CLI, we checked the ntp server configuration of both primary and secondary nodes they are the same. We tried...
First off a nod to ChiefSec-SF & Orlith for their contributions.Objective: Use PowerShell to create a new Event Stream. Define Authentication Credentials$Credentials = GET-CREDENTIAL –Credential (Get-Credential)
Hello. Hoping someone out there may be able to help us figure out a nagging issue with our ISE deployment. We are running ISE 2.4 along with 802.1x/MAB authentication for our Win 10 machines and Shoretel phones. We run 2960 switches at the acces...