I have the follow Cisco switch:
WIENEU_CORE#sho ver
Cisco IOS Software, C3550 Software (C3550-IPBASE-M), Version 12.2(25)SEB4, RELEASE SOFTWARE (fc1)
Copyright (c) 1986-2005 by Cisco Systems, Inc.
Compiled Tue 30-Aug-05 13:14 by yenanh
ROM: Bootstrap program is C3550 boot loader
WIENEU_CORE uptime is 3 years, 5 weeks, 5 days, 1 hour, 34 minutes
System returned to ROM by power-on
System restarted at 16:10:29 GMT Tue Sep 12 2006
System image file is "flash:c3550-ipbase-mz.122-25.SEB4/c3550-ipbase-mz.122-25.SEB4.bin"
Cisco WS-C3550-48 (PowerPC) processor (revision S0) with 65526K/8192K bytes of memory.
Processor board ID CAT1012Z3P5
Last reset from warm-reset
Running Layer2/3 Switching Image
Ethernet-controller 1 has 12 Fast Ethernet/IEEE 802.3 interfaces
Ethernet-controller 2 has 12 Fast Ethernet/IEEE 802.3 interfaces
Ethernet-controller 3 has 12 Fast Ethernet/IEEE 802.3 interfaces
Ethernet-controller 4 has 12 Fast Ethernet/IEEE 802.3 interfaces
Ethernet-controller 5 has 1 Gigabit Ethernet/IEEE 802.3 interface
Ethernet-controller 6 has 1 Gigabit Ethernet/IEEE 802.3 interface
48 FastEthernet interfaces
2 Gigabit Ethernet interfaces
The password-recovery mechanism is enabled.
384K bytes of flash-simulated NVRAM.
Base ethernet MAC Address: 00:17:94:23:1E:00
Motherboard assembly number: 73-5701-10
Power supply part number: 34-0967-03
Motherboard serial number: CAT10120FQQ
Power supply serial number: DTH1005895S
Model revision number: S0
Motherboard revision number: A0
Model number: WS-C3550-48-SMI
System serial number: CAT1012Z3P5
Configuration register is 0x10F
I have configured routing on, but when I try to configure eigrp i get the message 'Protocol not in this image'.
Can I upgrade or does the protocol not work on this device?
