cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
166
Views
0
Helpful
1
Replies
Highlighted
Beginner

LMS 2.6 RME collection status

In the RME collection status partially successfull config archive; some hosts are showing errors which read as follows:

" CM0012: Unable to create new version $1 Action: check if disk space is available and directory has required permissions "

The units in question have the same disk space as other units of the same type with the same permissions and are not showing this error I am comparing the flash dir. where else should I look to determine what the problem may be. cisco3650,and cisco3750 type devices

Byron

1 REPLY 1
Cisco Employee

Re: LMS 2.6 RME collection status

The CM0012 error is most likely caused by CSCsh39475. A patch is available on Cisco.com at http://www.cisco.com/cgi-bin/tablebuild.pl/cw2000-rme .

If, after applying this patch, you are still seeing errors, you should enable ArchiveMgmt debugging under RME > Admin > System Preferences > Loglevel Settings, reproduce the problem, then look at the dcmaservice.log for errors