cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
326
Views
0
Helpful
0
Replies
Highlighted
Beginner

show run monitor-interface does not show monitor-interfaces

Hi all,

 

have a quick question, our customer has configured two port channels

2 x Ten Gig Interface Fiber
2 x 1 GBit Interface Copper

however when perform show run monitor-interface nothing shows upno monitor-interface management
monitor-interfacexxxx
monitor-interface yyyy
monitor-interface zzzz

 

show fialover


This context: Active
Active time: 587644 (sec)
Interface management (x.x.x.x): Normal (Not-Monitored)
Interface xat (a.a.a.a): Normal (Waiting) <-outside interface
Interfacevb (b.b.b.b): Normal (Waiting) <-inside interface
Interface xc(c.c.c.c.c): Normal (Monitored)
Interfacexd(d.d.d.d): Normal (Monitored)
Interface xe (e.e.e.e): Normal (Monitored)
Peer context: Standby Ready
Active time: 52 (sec)
Interface management (x.x.x.x): Normal (Not-Monitored)
Interface xa (a.a.a.a): Normal (Waiting) <-outside interface
Interface xb (b.b.b.b): Normal (Waiting) <-inside interface
Interface xc (c.c.c.c.c): Normal (Monitored)
Interface xd (d.d.d.d.d.d): Normal (Monitored)
Interface xe (e.e.e.e.e): Normal (Monitored)
=================================

apologies, i cannot share any other information, only if I escalate this to TAC, but want to see whether anyone here knows something before escalation

thanks in advance

Lance

Everyone's tags (1)