I am stumped why is it I can ping from a host in Site A connected to FTD inside interface to a host in Site B ASA inside interface over S2S tunnel but I cannot ping from either side from the FTD or ASA. The FTD IP addresses for managemen...
view more
We have AnyConnect configured on an FTD, and we want to remove split tunneling. On our ASA, we have a route similar to the following: route inside 0.0.0.0 0.0.0.0 10.1.0.1 tunneled, where all our AnyConnect traffic is routed to the internal core swit...
view more
We recently implemented a firepower 1140 running 7.0.1-84. We would like to allow host on our inside network to ping & tracert a host on our DMZ, and vice versa. Our DMZ and inside network have dedicated interface on the firepower. when I create ...
view more
Hello allI am struggling with something on our Azure setup.I have created public load balancer with two ASAv's behind it running active/standby HA.I am fairly sure that when I set them up and configured HA, that it was working OK. But a few weeks later, t...
view more
TAC support has gotten really bad for the past few years. I've many cases opened and it just drags on for months without any resolutions. The TAC engineers are not very responsive. For example, I opened a TAC case on 06/24 for an issue.&...
view more