Server Networking

Is there a URL I can download Cisco Device Manager for Nexus 5000?  Is this the same Device Manager I use for Catalyst 6500?  I'm just doing Layer2 no FCOE and don't need Fabric Manager -jason

Hello,I have installed vmware ESX 4.0.4, downloaded "cisco-vem-v110-4.0.4.1.2.0.81-1.11.11.zip" and "cross_cisco-vem-v110-4.0.4.1.2.0.81-1.11.11-release.vib" on the /tmp folder.The installation package failed using the command "vihostupdate" or "esxu...

Just set up a VPC peer-link between two 7010 switches.  The peer-link is a port-channel of two 10Gb connections.  On both sides I'm seeing this in the log:2010 Jan  5 04:27:34 CRMCN7K-1 %ARP-2-DUP_SRC_IP:  arp [3069]  Source address of packet receive...

I have been asked to give different users profiles for storage admins and regular users on N5K. The storage admin would have access only to FCoE configuration, FC interfaces, etc, while the regular admin would not have acess to disable a fibre channe...

Has any one created a role for just SAN guys to come in and config the zone information?  ANd are there any good places out there that can help me to define what I can and cannot add to a role.  Thanks

Hello,could someone please answer my very simple question:Do we have to use dedicated physical network interfacecards for nexus control and mgmt for the communcation between the VSM and the VEM or can i use a trunk to transport each of these traffic ...

Hi folks,A while ago there was a discussion on this forum regarding the use of Catalyst 3020/3120 blades switches in conjunction with VN-tag.  Specifically, you can't do VN-Tag with that Catalyst blade switch sitting inbetween the Nexus 1000V and the...

Hi there,I am currently evaluating different vendor CNAs and therefore I need to configure different queues with different 802.1p priority bits.I added a new QoS policy map and my config looks like this now: Type qos policy-maps  ====================...

Hi there,I hope somebody can help us. We recently bought some HP c7000 Blade Enclosures with 2 Cisco 3120x switches inside. On the blades we run Windows Server 2003 and 2008 and use teaming.When a switch needs to be replaced after an hardware failure...

Hi,I need help with a VMware & Nexus 1000v setup. I'm trying to get trunk uplinks working on VM hosts.I've created uplink port-profiles and vmware port-groups on the VSM and I've assigned the physical adapters on the VM hosts to the appropirate uplin...

Hi,I would like to know:How can I replace device-alias pWWN using command line?How can I add a new pWWN to device-alias using command line?Thanks.

1. Could you please help me out here. I am setting up syslog on Nexus switches and running into problems (error messages at bottom).On Nexus 5000, I am trying to disable CFS distribution for application SYSLOGD, but do not find a command to do that.W...

Hi all,I need to achieve an high availability for all the servers having only two NICs belonging to different VLANs with a particular configuration.Infact, these servers are connected as shows at following:(VLAN1) -->Server1--> (VLAN2) -->Server2 -->...