Server Networking

Hi, I am converting a Cat6509 Sup720 CatOS to IOS.The switch also has a FWSM configured. During converting CatOS to IOS will the FWSM configuration be erased or affected by any means ?RegardsKas

Hi All, I would like to thank you for your help and your support.However, I am going to implement NAT solution inside my organization with 3 goals:-1- Allow 2 Internal users ( CEO & VP ) to access Internet [using Static], using 2 Real IP assigned fr...

For 1000 users, what is the bandwidth for backbone to run VoIP and video?Thanks

A client is requesting various site survey's but must have secret clearance. I'm trying to determine the cost of conducting a site survey with the assumption that these sites are military since requesting secret clearance? CITS Baseline of equip wi...

Can someone tell me if it is possible to implement L2TPv3 on the standard C3750 or if this is only possible on the Metro hardware. We have 2 data centres for redundancy and have implemented a fully routed core/distribution, however we do not wish to ...

I have a pair of 11506 CSS and 4506 switches with sup IV. I would like to use the switch to route because it would provide me with faster route speeds, since it would use MLS and provide me wire speeds instead using the Route Processsor all the time...

I have an objective to transparently interconnect two Cat 6506 switches using dot1q trunk via ethernet switched and IP routed enviroment.6506 trunk - 3560 dot1q tunnel via vlan 2 - 7206 terminating vlan 2 and xconnect to neighbor 7206 - 3560 with vla...

Dear My reader,I have this idea in my mind, and i am searching for your advice, in order to go ahead and implement it or stop even thinking about it.the idea is :-My mail server is hosted in my isp side, and inside my company here i do not have any i...

As Dell and Sun provide PCI-x or PCI-e only, with just 2 build-in NICs, while server admins are quite reluctant to add additional NIC to run in traditional way, like Front-end NIC, Backup NIC, Load-Balancing-NIC, Mgmt NIC cause the PCI-x or PCI-e are...

has anyone started using the ACE module in the Cat6500 for server load balancingArni

I am moving this to the correct forum.

Dear All,I HAVE cisco 1841.it has 2 interfaces.the first one which is f 0/0 is have public ip from my ISP.the other one is normal, and i am going to give it 192.168.1.100 / 24.now i have 3 subnets totally diffrent .i want to create 3 subinterfaces fr...