Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
1811
Views
0
Helpful
1
Replies

HyperFlex Installer Re-IP

kjp1231
Level 1
Level 1

‎03-13-2019 04:15 PM

I have my HyperFlex installer stood up and configured, but now I need to change it's IP address.

 

Is there a method for doing this?

Any caveats to doing this?

 

Thanks

Labels:
0 Helpful
1 Reply 1

Gary Wong
Cisco Employee
Cisco Employee

‎03-19-2019 01:30 AM

You can modify it a few different ways.

 

1. Re-deploy the Installer VM with the correct IP configuration

2. Edit /etc/network/eth0.interface with the correct configuration and reboot to take effect

3. You can use `ip addr set` command

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents