cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
368
Views
0
Helpful
2
Replies
Highlighted
Beginner

New Catalyst 4500X is not passing traffic.

I have a new Catalyst 4500X switch.  I have the basic config on it, with ports configured as trunks, with nonegotiate.  When I plug the switches in, the ports come up and CDP shows my neighbors.  However, when I try to ping the other switches, it won't go through.  IP Default-Gateway is setup, but I'm not sure what else I'm missing.  Is there something on a 4500X switch that is different than a 3560 or 3560X switch?  Shouldn't it start forwarding packets as soon as a trunk is established?  All my VLANs are up too.

Everyone's tags (3)
2 REPLIES 2
Beginner

Config attached.

Config attached.

Here's the software that I'm using:  cat4500e-universal.SPA.03.06.00.E.152-2.E.bin

Highlighted
Cisco Employee

I see the following config:

I see the following config:

interface Vlan117
 ip address 10.1.17.32 255.255.255.0
 ip helper-address 10.1.1.71
!
ip default-gateway 10.1.1.1
ip forward-protocol nd
no ip http server

 

whats the ip address are you trying to ping the other end?