I have a Cisco Nexus 5596 with 48 Ethernet Ports (two of which are now configured for Fibre Channel). It has a FEX attached to it as well.
I was able to configure ANY Ethernet port with the typical interface commands when in interface configuration mode. However, I can now only configure existing and new Port Channel interfaces, FEX ports and standard Ethernet ports that have never been configured before.
If I try to configure an Ethernet interface that was configured in the past, I only seem to have access to global interface commands when in interface configuration mode. I can set spanning-tree, duplex, speed or any other interface parameters. The CLI acts like I'm not in interface config mode, but the prompt shows that I am.
Anyone else seen such a thing? I am logged in as admin.
I suspect the interface in question is configured to be in a channel. Once an ethernet interface is configured to be in a port-channel. most interface commands need to be configured under the port-channel interface
New Cisco Champion Radio release on Cisco Intersight Cloud Operations PlatformListen: https://smarturl.it/CCRS8E15Follow us: https://twitter.com/CiscoChampion Known as Project Starship when it was introduced in June 2017, Cisco Intersight has come a ...
Join us live on Thursday, April 8 at 10 am PT (and on demand after) as we join Cisco and HashiCorp executives to discuss the importance of IaC automation, Intersight Service for Terraform, and how to better manage hybrid cloud infrastructure at scale...
Join us live on Thursday, April 8 at 10 am PT (and on demand after) where Cisco and HashiCorp executives will discuss the importance of IaC automation, Cisco Intersight Service for Hashicorp Terraform, and how to better manage hybrid cloud infrastructure...
How to START with Infrastructure as a code for Cisco Cloud Solutions
ACI Ansible Modules Documentation Guide
Cisco Collections on Ansible Galaxy
Cisco DevNet Learning Labs
DevNet Introduction to ACI and Ansible
DevNet Introduction to ACI a...