cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1422
Views
0
Helpful
2
Replies

Nexus 7018 to HP Virtual Connect Flexfabric

Julio Sosa
Beginner
Beginner

Hi,

I have a lot of problems to connect a HP VC FlexFabric to my Nexus 7K. First, we tried to form a etherchannel, it was impossible then we tried to connect in access mode with same results

Here some info about that:

>------ LOG ------<

CEP_N7018 %ETHPORT-5-SPEED: Interface Ethernet3/17, operational speed changed to 10 Gbps

2011 Sep 12 16:39:20 CEP_N7018 %ETHPORT-5-IF_DUPLEX: Interface Ethernet3/17, operational duplex mode changed to Full

2011 Sep 12 16:39:20 CEP_N7018 %ETHPORT-5-IF_RX_FLOW_CONTROL: Interface Ethernet3/17, operational Receive Flow Control state changed to on

2011 Sep 12 16:39:20 CEP_N7018 %ETHPORT-5-IF_TX_FLOW_CONTROL: Interface Ethernet3/17, operational Transmit Flow Control state changed to on

2011 Sep 12 16:39:20 CEP_N7018 %ETHPORT-5-IF_UP: Interface Ethernet3/17 is up in mode access

2011 Sep 12 16:39:20 CEP_N7018 %ETHPORT-5-IF_DOWN_LINK_FAILURE: Interface Ethernet3/17 is down (Link failure)

¿Anybody knows about problems or issues related to connect these kinds of equipments?

Regards,

2 Replies 2

Jerry Ye
Cisco Employee
Cisco Employee

Can you post the config of the E3/17?

Is your N7K vPC?

Regards,

jerry

Hi,

We did with this bug and implement the workaround:

CSCtq02005

10GBASE-SR flap at linkup between N7K-F132XP-15 and HP FLex

Thanks

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: