Good morning,
I am trying to find why our N2K are sending pause frame to the host when to uplink is not congested.
fex is a 2232
N5K running 7.1
sample interface counters :
Ethernet109/1/2 is up
Hardware: 1000/10000 Ethernet, address: d4d7.481c.4143 (bia d4d7.481c.4143)
Description: #lx#lpdatgfs002b#slot51
MTU 1500 bytes, BW 10000000 Kbit,, BW 10000000 Kbit, DLY 10 usec
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA, medium is broadcast
Port mode is trunk
full-duplex, 10 Gb/s, media type is 10G
Beacon is turned off
Input flow-control is off, output flow-control is on
Rate mode is dedicated
Switchport monitor is off
EtherType is 0x8100
Last link flapped 2week(s) 3day(s)
Last clearing of "show interface" counters never
7 interface resets
30 seconds input rate 6110680 bits/sec, 2471 packets/sec
30 seconds output rate 21613216 bits/sec, 3089 packets/sec
Load-Interval #2: 5 minute (300 seconds)
input rate 5.78 Mbps, 2.13 Kpps; output rate 23.44 Mbps, 2.99 Kpps
RX
10091193922 unicast packets 262347 multicast packets 1445 broadcast packet
s
10091457714 input packets 11415744353925 bytes
7327506834 jumbo packets 0 storm suppression bytes
0 runts 0 giants 0 CRC 0 no buffer
0 input error 0 short frame 0 overrun 0 underrun 0 ignored
0 watchdog 0 bad etype drop 0 bad proto drop 0 if down drop
0 input with dribble 0 input discard
0 Rx pause
TX
5866855122 unicast packets 752565969 multicast packets 3756512 broadcast p
ackets
6623177603 output packets 7759606240442 bytes
4964130638 jumbo packets
0 output error 0 collision 0 deferred 0 late collision
0 lost carrier 0 no carrier 0 babble 0 output discard
750462164 Tx pause
Thank you for your help.