Hi Folks, Hitesh Kumar (CCIE SP #38757) and myself Rahul Rammanohar CCIE (R&S, SP #13015) work for the High Touch Technical Support (HTTS) team here at Cisco. Our team provides reactive technical support to majority of Cisco’s premium customers. We have created the following video that includes packet capture capabilities across multiple Cisco routers and switches. For each product, we start off by talking about the theory of the capability, followed by an explanation of the commands and finally a Demo on real devices.
We will take your questions and follow up on this video with an 'Ask The Expert' event soon, look forward to seeing you there.
Agenda with the timestamp when each of the packet capture capability begins.
00:00 - Introduction
01:20 - 7600/6500 - Mini Protocol Analyzer (MPA)
08:39 - 7600/6500 - ELAM
15:30 - 7600/6500 - Netdr
19:38 - ASR9k - Network Processor Capture
28:00 - 7200/ISRs - Embedded Packet Capture
34:55 - Nexus 7K, 5K and 3K - Ethanalyzer
43:42 - Nexus 7K - ELAM
52:37 - CRS - Show Captured Packets
56:45 - ASR1K - Embedded Packet Capture
Thanks for watching our video, feel free to post your questions, comments and feedback below.
Hi, I'd like to ask how to check via SNMP signal to noise ratio or number of codewords (without errors, with correctable errors etc.) on interfaces connected to CTMS via R-PHY shelf. So far, I've been using OIDs from DOCS-IF-MIB (like for exampl...
Hello! I have several IOS-XR routers and have been monitoring them with SNMPv3 for quite some time. We have them configured with an OSPF underlay with LDP, and then use L3VPNs/VRFs for public internet interfaces. I am running into a problem using SNM...
Hello,How can I verify status of license (Ten Gigabit Interfaces) loaded on secondary (standby) pre 5 procesor on my ubr 10k platform?Command show licence display info about primary processor:Index 1 Feature: WAN_LicensePeriod left: Life timeLicense Type:...
Hello,( R1 ) -ibgp-> ( R2 ) -ebgp-> ( R3 )The scenario is that router R1 is announcing routes to R2. Those routes are tagged from R2 inbound using RPL (community is 123:123). Now the R2 has an RPL policy towards R3 which dictates to match any r...
Hi All, I have an ASR 9000, but it doesn't support MPLS. The current release is 4.2.1, and if is it possible for me to upgrade it to 4.3.4? When I login with my CCO account, I found the software is 4.3.4(MD), and why it has an MD? Thanks,Mei&nbs...