IOS-XR has a very strong embedded mechanism to do user authentication and authorization. While XR does not have the concept of privilege-levels as what IOS had, the embedded user task group management is extremely strong allow for the creation of different task groups.
Building blocks for on-box authorization scheme 4 types of permissions per task
The following task-groups are predefined in IOS-XR
Hi All,I am trying to make the mpls-ping work between my proprietary PE router xxx1234 and ASR9K router. It seems that mpls-ping packets are getting dropped at ASR9K.xxx1234# mpls-ping 18.104.22.168Invalid IP/mask syntaxxxx1234# mpls-ping 15.1....
Hello,I have C892FSP-K9. To port 1 and 2 enters the same multicast, then it is tunneled through xconnect and exits by port 9.The problem is that traffic from port 1 + traffic from port 2 does not equal port 9 - On port 9 it is too low.This is reflected in...
HiWe have a call flow as below:CUCM --H323 Trunk--ISR4300--SIP Trunk---ITSP (PSTN) The CUCM Users are able to make calls outside to PSTN but the DTMF wont work.The things already done as troubleshooting:1. MTP configuration on ISR4300 and register in...
Hi,Is there a way to automatically map routes to different TE tunnels based on some criteria like BGP communities for example?I know we can map them based on CoS using CBTS, but can we do it based on communities?In Juniper this can be done using "install-...
Hi Community, Can you advise if upgrade process of ASR9006 from 5.x to 6.x is any different to the upgrade of 9001? I'm wondering especially regarding the dual RP in 9006. Is there any official pdf from Cisco for dual RP? Thanks.