Cisco Crosswork Network Automation (CNA) is a micro-services platform that brings together streaming telemetry, big data, and model-driven application programming interfaces (APIs). This demonstration highlights the CNA applications, Health Insights and Change Automation:
Health Insights is a network health application that performs real-time key performance indicator (KPI) monitoring, alerting, and troubleshooting.
Change Automation is an application that automates the process of deploying changes to the network.
Scenario 1: Add Devices, Verify Initial Topology, and Router Configuration
Scenario 2: Configure KPIs in Health Insights
Scenario 3: Verify KPIs
Scenario 4: Detect a Problem in the Network
Scenario 5: Remediate Issues with Change Automation
Scenario 6: Apply Software Update with Change Automation
Scenario 7: Blackhole Detection
Crosswork Network Automation 1.2
Health Insights 1.2
Change Automation 1.2
IOS XRv 9000 6.2.1
Crosswork Network Automation
Application infrastructure based on Industry Standards
Collector services for apps with Normalization
Monitor KPIs in Real Time
Alerts on spikes and drops
Configure SLA thresholds
Automate network changes
Closed loop detection and resolution
Virtual environment for building network topologies
Simulation of networking components
Capable of running a range of virtual machines (VMs) running Cisco operating systems (IOS-XE, IOS Classic, IOS-XR, and NX-OS)
Support for third-party VMs
Capture and analyze network traffic at any node
Validate configurations prior to physical deployment
IOS XRv 9000
Full IOS XR control plane router
Traffic Generator with dynamic configuration
Can create background traffic in meshes between all nodes
Hey all, i am having an issue where the number of subscriber sessions connected are decreasing.Memory and Hard disk state are normal.does anyone know what is causing this decrease of connected session? Thank you,
anyone using it ? Followed the guide fromhttps://github.com/ios-xr/bgpfs2acl A bit confusing especially i have almost no knowledge on docker commands. Managed to clear step 2. At step 3, when running "source run_container.sh"It seems l...
Hallo everyone ,i have a 10 G interface for Core Device (Catalyst 6880), i want to check if everything ok on this Interface , but theres hight Output Drop Number i dont know if this still normal in compare with all Output Packets ?? , this interface is co...
Telemetry (MDT) sensor-path for interfaces is not sending any info about sub interfaces (logical interfaces) on latest IOS-XE. We found that counters for sub interfaces are not in IOS process but only in SNMP one (that is probably the key...
Supported for NCs-5501-SE? Found this from ->https://www.cisco.com/c/en/us/td/docs/iosxr/ncs5500/ip-addresses/65x/b-ip-addresses-cg-ncs5500-65x/b-ip-addresses-cg-ncs5500-65x_chapter_0111.html However, while inside GRE tunnel configurati...