Cisco's Nick Fielibert's session presentation from ANGA 2014 in Cologne, Germany. Access all Cisco at ANGA assets (blogs, photos, event details, etc.) here: http://cs.co/fbet
Dears, I have ASR 9K with RSP board type of (A9K-RSP880-SE) and GPS ports (1PPS, 10MHz and RS232) are connected to the RSP board but the GPS light in the RSP isn't turning up. Your suggestion is highly appricated. Regards
Hi, I have a problem in my small PBB-EVPN lab installation.Two PE routers (ASR9904) are directly connected via a 100GE link. On these two routers, a full and correct operating PBB-EVPN configuration is implemented.The ingress ports on the access side...
view more
Hello everyone,We're having a little issue which we've been struggling with over the past few days.We have a PE with a LACP L2 bundle-ethernet interface comprised of two GigabitEthernet physical interfaces, which are facing customer equipment. We provide ...
view more
Hi, am faced with a rather weird one. I have configured a L2VPN between a pair of NCS5501`s, and connected end devices(CPEs) to the attached VLAN. All is working, except connectivity to a BVI interface configured on on one of the routers, from the remote ...
view more
