cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

Cisco Community Designated VIP Class of 2020

EoMPLS between 7604 and ASR9000

73
Views
0
Helpful
0
Comments

Dear collegues

We have Cisco 7604 and ASR 9000 connected together via 10GE interface. Our 7604 has ES+ core-facing module and not ES+ on AC side. 

We are implementing EoMPLS between them but VC doesn't come up.

Does anyone have some consideration about what the problem is?

We have following connections:

Catalyst 3750 <---->  Ge 1/2 Cisco 7604 TE 4/4 <----> Te0/0/0/0 ASR9000 Te0/0/0/1 <----> ME 3600

Here is the output os show ... command

7604#sh module

Mod Ports Card Type                              Model             

--- ----- -------------------------------------- ------------------ -----------

  1    2  Route Switch Processor 720 (Active)    RSP720-3C-GE     

  2    4  CEF720 4 port 10-Gigabit Ethernet      WS-X6704-10GE    

  3   24  CEF720 24 port 1000mb SFP              WS-X6724-SFP      

  4    4  7600 ES+T                              76-ES+T-4TG       

7604# sh mpls l2transport vc 2 detail

Local interface: Gi1/2.528 up, line protocol up, Eth VLAN 528 up

  Destination address: 10.1.0.1, VC ID: 2, VC status: down

    Output interface: Te4/4, imposed label stack {16002}

    Preferred path: not configured 

    Default path: active

    Next hop: 10.1.1.1

  Create time: 04:14:29, last status change time: 00:22:04

  Signaling protocol: LDP, peer 10.1.0.1:0 up

    Targeted Hello: 10.1.0.2(LDP Id) -> 10.1.0.1, LDP is UP

    Status TLV support (local/remote)   : enabled/supported

      LDP route watch                   : enabled

      Label/status state machine        : established, LruRrd

      Last local dataplane   status rcvd: No fault

      Last BFD dataplane     status rcvd: Not sent

      Last local SSS circuit status rcvd: No fault

      Last local SSS circuit status sent: DOWN(PW-tx-fault)

      Last local  LDP TLV    status sent: No fault

      Last remote LDP TLV    status rcvd: DOWN(PW-tx-fault)

      Last remote LDP ADJ    status rcvd: No fault

    MPLS VC labels: local 17, remote 16002

    PWID: 20639

    Group ID: local 0, remote 67109120

    MTU: local 9202, remote 9202

    Remote interface description: TenGigE0_0_0_1.100

  Sequencing: receive disabled, send disabled

  Control Word: On (configured: autosense)

  SSO Descriptor: 10.1.0.1/2, local label: 17

    SSM segment/switch IDs: 8353/12403 (used), PWID: 20639

  VC statistics:

    transit packet totals: receive 0, send 2

    transit byte totals:   receive 0, send 180

    transit packet drops:  receive 0, seq error 0, send 0

RP/0/RSP0/CPU0:ASR9000#sh l2vpn xconnect detail

Tue Feb 14 08:51:13.163 UTC

Group Backbone1, XC to7604, state is down; Interworking none

  AC: TenGigE0/0/0/1.100, state is up

    Type VLAN; Num Ranges: 1

    VLAN ranges: [100, 100]

    MTU 9202; XC ID 0x840001; interworking none

    Statistics:

      packets: received 0, sent 0

      bytes: received 0, sent 0

      drops: illegal VLAN 0, illegal length 0

  PW: neighbor 10.1.0.2, PW ID 2, state is down ( remote standby )

    PW class dynamic_mpls, XC ID 0xc0000001

    Encapsulation MPLS, protocol LDP

    Source address 10.1.0.1

    PW type Ethernet VLAN, control word enabled, interworking none

    PW backup disable delay 0 sec

    Sequencing not set

    PW Status TLV in use

      MPLS         Local                          Remote                       

      ------------ ------------------------------ -----------------------------

      Label        16002                          17                           

      Group ID     0x4000100                      0x0                          

      Interface    TenGigE0/0/0/1.100             unknown                      

      MTU          9202                           9202                         

      Control word enabled                        enabled                      

      PW type      Ethernet VLAN                  Ethernet VLAN                

      VCCV CV type 0x2                            0x12                         

                   (LSP ping verification)        (LSP ping verification)      

      VCCV CC type 0x7                            0x6                          

                   (control word)                                              

                   (router alert label)           (router alert label)         

                   (TTL expiry)                   (TTL expiry)                 

      ------------ ------------------------------ -----------------------------

    Incoming Status (PW Status TLV):

      Status code: 0x0 (Up) in Notification message

    Outgoing Status (PW Status TLV):

      Status code: 0x10 (PW Down) in Notification message

    MIB cpwVcIndex: 3221225473

    Create time: 14/02/2012 08:26:46 (00:24:26 ago)

    Last time status changed: 14/02/2012 08:27:57 (00:23:15 ago)

    Statistics:

      packets: received 0, sent 0

      bytes: received 0, sent 0

CreatePlease to create content
Content for Community-Ad
FusionCharts will render here