"The first two platforms will allow service providers to deploy all types of services (voice, video, or data) to all types of customers (consumer, mobile or business) on a single, converged Carrier Ethernet-based IP network, and both are optimized for low power consumption and extended temperatures:
The Cisco ASR 901 is a compact, cell-site Ethernet access router specifically designed to clock, aggregate, and backhaul any-G RAN traffic, and can prioritize and process voice, data, and signaling traffic as part of the Cisco Unified RAN solution for reliable transport across any available mobile network.
The Cisco ASR 903 is a fully-featured Carrier Ethernet aggregation platform designed for the cost-effective delivery of converged services. With full redundancy and high service scale, this compact (3RU) router is optimized for small aggregation and remote POP applications and provides a rich and scalable set of Layer 2 and 3 VPN services.
And the third platform, the Cisco ASR 9001, is a smaller version of our industry-leading Cisco ASR 9000 edge router, specifically designed for low-capacity deployments.
These new platforms complement the rest of the Cisco ASR 9000 family to deliver a single, simplified system for high-speed business, residential and mobile connectivity. And as with the rest of the ASR 9000 System, they all support Cisco’s nV Technology for simplified network architectures..." Read more or watch the video below.
Hallo, we are running IOS XR 6.6.3(64-bit) on an ASR 9904 with redundant RSP5 and A9K-24X10GE-1G-SE Linecards.In order to upgrade from 6.6.3 to 7.5.2 i have to instrall 3 SMU´sasr9k-x64-6.6.3.CSCvr47102.tarasr9k-x64-6.6.3.CSCvu75507.tarasr9k-x64-6.6....
view more
Hi All,Need a small help here.My customer currently doesn`t use Cisco Service Provider products much in its architecture.Hence, I was preparing for SPCOR exam earlier but then stopped after looking their existing and new service provider architecture.Henc...
view more
Hello All, I have configured VPLS on the following setup.VPLS-VPWS neighborship is up between XRv routers and L2 routes are exchanged but ping is not working between IOS11 and IOS22. Am I missing any configuration ? ios11(g0/0)----(g...
view more
Hello, I have configured VPLS on following setup.ios12----CSR1----CSR2---ios13But I can not ping from ios12 to ios13.ios12#ping 100.10.10.13Type escape sequence to abort.Sending 5, 100-byte ICMP Echos to 100.10.10.13, timeout is 2 seconds:.....Succes...
view more
Hello All, I am trying to configure optimal route reflector. IOS1 is ebgp neighbor to CSR2 and CSR3. CSR2, CSR3, XRv-RR and XRv3 are part of same AS 123. I have configured optional route reflection on XR-RR. But I do not see any prefix on XRv7.I am n...
view more