We were just issued our IPv6 address block by Arin, and it came with three ASNs. Could you provide any information on why there are three (instead of just one)? Also, would I use one of those ASNs for my EIGRP routing on the inside or are those only for use with my BGP routing to our ISPs? (in other words, can I use a private ASN for EIGRP on the inside or will that mess things up?) Thanks much!
Today I was studying the seamless MPLS approach from this page:https://www.cisco.com/c/en/us/support/docs/multiprotocol-label-switching-mpls/mpls/116127-configure-technology-00.html But there is a point where I really struggle.See the picture below.H...
Quick Question please, In MPLS network with VRFs, there are two labels on the packet, one is the MP-BGP label and the other is LDP label. Does the MP-BGP label have EXP bit? Or it's only on the LDP label? Thank you
Having an issue where the amount of radius sessions are not in sync with the BNG sessions. We use IPoE for authentication, so any COAs that need to sent from radius to the bng need to be known by radius and that is where the issue lies. ...
I'm reviewing our hardware for replacement planning, and have most of the EoS dates, except for the following:ASR-9001A9K-MPA-20X1GEA9K-MPA-4X10GEA9K-MPA-8X10GE Any info or references are appreciated. Thanks,Phil