Or Is it "necessary" to apply priority queue outbound on an interface a phone is attached? Thanks. Is below config a common practice?!policy-map QOSclass VOICEpriority level 1!police rate percent Xpolicy-map QOSservice-policy output Q...
view more
Is there any way to remove virtual-service vnics configuration without vsm card? I uninstalled vsm card without removing the vsm config. And now, I am unable to remove the config. It gives the following error with committing. % Failed ...
view more
Multiple Cisco IAD2431-16FXS units convert analogue phones to VOIP through separate SIP trunks. This has been working for a year but just last week outgoing calls failed (incoming are fine). Dial tone is available but after dialling, the line goes silent....
view more
Hi all, I am trying to lab a scenario for L3VPN where I do have a BGP VPNv4 RR and multihomed customers (CEs).I wonder if we can utilize the mulitpathing using BGP diverse-path (IOS XE) or BGP Add-path (IOS XR) on the RR without changing the RDs.The ...
view more
We are facing call transfer issue where using Genesys PBX where VGW is Cisco 4431 router ...how do we troubleshoot on VGW end ...MGCP gateway configured ..attaching VGW config..which debug command will give idea when the call transfer fail
