Console access to the router and Router must be running release 5.3.2 or higher
System must not have 800G (tomahawk) line cards, (see caveat (a) in list below)
Before the upgrade process starts, and prior to removing any RP from the chassis, make sure that “show redundancy” shows NSR and standby card is ready.
Make sure any none 5.3.x software is removed from the system (ie admin install remove *4.3.4*)
Enable console logging on the router and on the terminal application (optional)
a)The system must NOT have Tomahawk(400G or 800G) Line cards in the chassis prior to attempting this as the EOBC link between Tomahawk and newly inserted RP2 will be down which will interfere with the failover from RP1 to RP2. If there are Tomahawk cards in the chassis, they need to be removed or powered down for the upgrade to be successful. ‘admin-config #hw-module power disable location 0/1/cpu0’
3) Upgrade process:
1)Issue show redundancy and make sure NSR and Standby card is ready
Hi, We are facing issue with ASR 9904 line card. After power on line card status led is amber only and showing below errorRP/0/RSP0/CPU0:mes-ngl-pbx-pbx-cdi-1#0/RSP0/ADMIN0:Sep 19 15:14:28.524 UTC: canbus_driver: %PLATFORM-CANB_SERVER-3-ALARM_I...
How can I learn about ASR9K MPLS Label limits(LIB and LFIB max numbers).Is there any command to check on the device?
Are these limits changing with LCs and RSPs types.Is there any scaling document to get these values?
I want to learn about to 'Partially-programmed' errors at the output of command 'show l2vpn bridge-domain summary'. I can not find any related document about this part and how to troubleshoot if it is not equal to zero.
I am looking for...
Hi Friends, I have an ASR 1001(Cisco IOS XE Software, Version 03.16.01a.S/Cisco IOS Software Version 15.5(3)S1a).I checked it, but can't configure 'MPLS ldp', and no MPLS command under the interface. My question is which lowest release can ...
It is established that auto-upgrade should be disabled during an XR upgrade process. However, what is recommended for normal operations? I can see the advantage of having "auto-upgrade" in place so that any RMA or new LC's would/should be upgra...