Console access to the router and Router must be running release 5.3.2 or higher
System must not have 800G (tomahawk) line cards, (see caveat (a) in list below)
Before the upgrade process starts, and prior to removing any RP from the chassis, make sure that “show redundancy” shows NSR and standby card is ready.
Make sure any none 5.3.x software is removed from the system (ie admin install remove *4.3.4*)
Enable console logging on the router and on the terminal application (optional)
a)The system must NOT have Tomahawk(400G or 800G) Line cards in the chassis prior to attempting this as the EOBC link between Tomahawk and newly inserted RP2 will be down which will interfere with the failover from RP1 to RP2. If there are Tomahawk cards in the chassis, they need to be removed or powered down for the upgrade to be successful. ‘admin-config #hw-module power disable location 0/1/cpu0’
3) Upgrade process:
1)Issue show redundancy and make sure NSR and Standby card is ready
Hi Friends, I have an ASR 1001(Cisco IOS XE Software, Version 03.16.01a.S/Cisco IOS Software Version 15.5(3)S1a).I checked it, but can't configure 'MPLS ldp', and no MPLS command under the interface. My question is which lowest release can ...
It is established that auto-upgrade should be disabled during an XR upgrade process. However, what is recommended for normal operations? I can see the advantage of having "auto-upgrade" in place so that any RMA or new LC's would/should be upgra...
Hi Everyone, I'd like to know what is most MPLS providers' SOP for their COS especially for Premium i.e. Voice. If you subscribed 10M Premium and exceed that amount, what happens? Assuming the the entire pipe purchased is 100Mb for argument sake and ...
TRAI Regulation on Inbound outbound calling in Domestic Call centres in India As govt of India is promoting to create jobs in rural area's in Big way we are getting stuck as there is no clarity of making or receiving calls in our centers in Rural Are...
Hi, I'd like to ask how to check via SNMP signal to noise ratio or number of codewords (without errors, with correctable errors etc.) on interfaces connected to CTMS via R-PHY shelf. So far, I've been using OIDs from DOCS-IF-MIB (like for exampl...