This document contains the slides for the live webcast.
Cisco expert Ron Weaver covered basic PNC operation, focusing on decoder management and service creation using a lab system. He also went through the steps of authorizing and managing decoders, creating and scrambling services, and allowing decoders to access the service.
How to access using the GUI
How to create a program or virtual channel
- Adding services - Adding tiers to the program - How to scramble the program
Decoder operation - Adding decoders to the database - Decoder profiles - How to authorize and deauthorize a decoder - Searching the decoder database
Open discussion on PNC operation
Ron Weaver is the tech lead for the DMN team in the Cisco Technical Assistance Center located in Lawrenceville, Georgia. Ron is responsible for supporting the DMN products for broadcasters, which include encoders, decoders, muxes, and control systems. He has worked for Cisco for 32 years, with 20 of those years working with digital video products and systems. Before joining the company, he spent four years in the air force, where he received his training in electronics.
Hallo, we are running IOS XR 6.6.3(64-bit) on an ASR 9904 with redundant RSP5 and A9K-24X10GE-1G-SE Linecards.In order to upgrade from 6.6.3 to 7.5.2 i have to instrall 3 SMU´sasr9k-x64-6.6.3.CSCvr47102.tarasr9k-x64-6.6.3.CSCvu75507.tarasr9k-x64-6.6....
Hi All,Need a small help here.My customer currently doesn`t use Cisco Service Provider products much in its architecture.Hence, I was preparing for SPCOR exam earlier but then stopped after looking their existing and new service provider architecture.Henc...
Hello All, I have configured VPLS on the following setup.VPLS-VPWS neighborship is up between XRv routers and L2 routes are exchanged but ping is not working between IOS11 and IOS22. Am I missing any configuration ? ios11(g0/0)----(g...
Hello, I have configured VPLS on following setup.ios12----CSR1----CSR2---ios13But I can not ping from ios12 to ios13.ios12#ping 126.96.36.199Type escape sequence to abort.Sending 5, 100-byte ICMP Echos to 188.8.131.52, timeout is 2 seconds:.....Succes...
Hello All, I am trying to configure optimal route reflector. IOS1 is ebgp neighbor to CSR2 and CSR3. CSR2, CSR3, XRv-RR and XRv3 are part of same AS 123. I have configured optional route reflection on XR-RR. But I do not see any prefix on XRv7.I am n...