Hi everybody, does anyone knows why, if I have a 1Gbps router interface and my ISP give me 1Gbps of Internet (that was tested) I'm still downloading at100Mbps? Is it necessary to change some behavior of the Cisco router ISR4331?? I have 1Gbps of Internet ... view more

Hi All,I am trying to make the mpls-ping work between my proprietary PE router xxx1234 and ASR9K router. It seems that mpls-ping packets are getting dropped at ASR9K.xxx1234# mpls-ping 15.1.1.15Invalid IP/mask syntaxxxx1234# mpls-ping 15.1.... view more

Hello,I have C892FSP-K9. To port 1 and 2 enters the same multicast, then it is tunneled through xconnect and exits by port 9.The problem is that traffic from port 1 + traffic from port 2 does not equal port 9 - On port 9 it is too low.This is reflected in... view more

HiWe have a call flow as below:CUCM --H323 Trunk--ISR4300--SIP Trunk---ITSP (PSTN) The CUCM Users are able to make calls outside to PSTN but the DTMF wont work.The things already done as troubleshooting:1. MTP configuration on ISR4300 and register in... view more

Hi,Is there a way to automatically map routes to different TE tunnels based on some criteria like BGP communities for example?I know we can map them based on CoS using CBTS, but can we do it based on communities?In Juniper this can be done using "install-... view more