8. During the boot process the image is copied first on to the memory(RAM) and is installed from memory(RAM). Once it is insalled from memory, it will copy the image back on to disk0: and reload the device. Wait till you get the message "SYSTEM CONFIGURATION COMPLETED"
Output of show install active when in memory,
RP/0/RSP0/CPU0:ios#sh instal active <SNIP> Active Packages: mem:asr9k-mini-p-4.2.0
Output of show install active after image copied on to disk0:,
RP/0/RSP0/CPU0:ios#sh instal active <SNIP> Active Packages: disk0:asr9k-mini-p-4.2.0
9. Restore disk mirroring if it was disabled in step 6. To restore disk mirroring, use the mirror command in the global configuration mode. For more information on the mirror command, see the "Boot Commands on Cisco IOS XR Software" module in Cisco ASR 9000 Series Aggregation Services Router System Management Command Reference.
RSP-440 can boot from the USB front panel port like this:
Hi Friends, I have an ASR 1001(Cisco IOS XE Software, Version 03.16.01a.S/Cisco IOS Software Version 15.5(3)S1a).I checked it, but can't configure 'MPLS ldp', and no MPLS command under the interface. My question is which lowest release can ...
It is established that auto-upgrade should be disabled during an XR upgrade process. However, what is recommended for normal operations? I can see the advantage of having "auto-upgrade" in place so that any RMA or new LC's would/should be upgra...
Hi Everyone, I'd like to know what is most MPLS providers' SOP for their COS especially for Premium i.e. Voice. If you subscribed 10M Premium and exceed that amount, what happens? Assuming the the entire pipe purchased is 100Mb for argument sake and ...
TRAI Regulation on Inbound outbound calling in Domestic Call centres in India As govt of India is promoting to create jobs in rural area's in Big way we are getting stuck as there is no clarity of making or receiving calls in our centers in Rural Are...
Hi, I'd like to ask how to check via SNMP signal to noise ratio or number of codewords (without errors, with correctable errors etc.) on interfaces connected to CTMS via R-PHY shelf. So far, I've been using OIDs from DOCS-IF-MIB (like for exampl...