To participate in this event, please use the button to ask your questions
This topic is a chance to discuss more about the Multi Protocol Label Switching (MPLS) technology and its typical applications. This session will cover all questions related to MPLS fundamentals including its supporting protocols (LDP, BGP), and its most common applications, such as BGP-less core networks, 6PE/6VPE migration mechanisms, L2 and L3 VPNs, both in intra-AS and inter-AS scope.
Ask questions from October Monday 15th to Friday 2nd of November, 2018
David Samuel Peñaloza Seijas works as a Senior Network Consulting Engineer at Verizon Enterprise Solutions in the Czech Republic. Previously, he worked as a Network Support Specialist in the IBM Client Innovation Center in the Czech Republic. David is an expert interested in all topics related to networks. However, he focuses mainly on data centers, enterprise networks, and network design, including software-defined networking (SDN). David has a long relationship with Cisco. He has been a Cisco Instructor for the Cisco Academy and was recognized as a Cisco Champion and aCisco Designated VIPfor 2017 and 2018. David holds a CCNP R&S, CCDP, CCNA Security, CCNA CyberOps and a CCNA SP certification. Currently, he is preparing for a CCDE.
David might not be able to answer each question due to the volume expected during this event. Remember that you can continue the conversation on the Service Providers community.
Dears, I have ASR 9K with RSP board type of (A9K-RSP880-SE) and GPS ports (1PPS, 10MHz and RS232) are connected to the RSP board but the GPS light in the RSP isn't turning up. Your suggestion is highly appricated. Regards
Hi, I have a problem in my small PBB-EVPN lab installation.Two PE routers (ASR9904) are directly connected via a 100GE link. On these two routers, a full and correct operating PBB-EVPN configuration is implemented.The ingress ports on the access side...
Hello everyone,We're having a little issue which we've been struggling with over the past few days.We have a PE with a LACP L2 bundle-ethernet interface comprised of two GigabitEthernet physical interfaces, which are facing customer equipment. We provide ...
Hi, am faced with a rather weird one. I have configured a L2VPN between a pair of NCS5501`s, and connected end devices(CPEs) to the attached VLAN. All is working, except connectivity to a BVI interface configured on on one of the routers, from the remote ...