This session will provide an opportunity to learn and ask questions about Cisco IOS XR Software architecture which is modular and fully distributed network operating system used by most of the leading service providers in the industry. IOS XR is widely used in big platforms like GSR, CRS, NCS and ASR9K etc. You will also learn different troubleshooting scenarios and use cases on Cisco IOS XR Infrastructure, Configuration Management, XR Monitoring and Operations, process crash decode etc. c.
To participate in this event, please use thebutton to ask your question.
Ask questions from Monday June 6 to Friday June 17, 2016
Raj Pathak is a customer support engineer in High-Touch Technical Services at Cisco specializing in service provider technologies and platforms. He serves as a support engineer for technical issues supporting Cisco IOS XR Software customers on Cisco CRS, ASR 9K and Cisco XR 12000 Series Routers. Raj has more than 10 years of experience in the IT industry and holds double CCIE certification (38760) in routing and switching and Data Center. He has already delivered webcast and other ask the expert session on cisco support community.
Sudhir Kumar is a customer support engineer in High-Touch Technical Services at Cisco specializing in service provider technologies and platforms. His areas of expertise include Cisco GSR, CRS, ASR 9K and Cisco XR 12000 Series Routers. Sudhir has more than 12 years of experience in the IT industry and holds CCIE certification (35219) in Service provider and Routing and switching and Data Centers. He has already delivered webcast and other ask the expert session on cisco support community.
We look forward to your participation. This event is open to all, including partners. Please Share this event in your social channels. Have a technical question? Get answers here before opening a TAC case by visiting the Cisco Support Community.
Hi, I'd like to ask how to check via SNMP signal to noise ratio or number of codewords (without errors, with correctable errors etc.) on interfaces connected to CTMS via R-PHY shelf. So far, I've been using OIDs from DOCS-IF-MIB (like for exampl...
Hello! I have several IOS-XR routers and have been monitoring them with SNMPv3 for quite some time. We have them configured with an OSPF underlay with LDP, and then use L3VPNs/VRFs for public internet interfaces. I am running into a problem using SNM...
Hello,How can I verify status of license (Ten Gigabit Interfaces) loaded on secondary (standby) pre 5 procesor on my ubr 10k platform?Command show licence display info about primary processor:Index 1 Feature: WAN_LicensePeriod left: Life timeLicense Type:...
Hello,( R1 ) -ibgp-> ( R2 ) -ebgp-> ( R3 )The scenario is that router R1 is announcing routes to R2. Those routes are tagged from R2 inbound using RPL (community is 123:123). Now the R2 has an RPL policy towards R3 which dictates to match any r...
Hi All, I have an ASR 9000, but it doesn't support MPLS. The current release is 4.2.1, and if is it possible for me to upgrade it to 4.3.4? When I login with my CCO account, I found the software is 4.3.4(MD), and why it has an MD? Thanks,Mei&nbs...