Webcast: Configuring and Troubleshooting MPLS VPN (Live Webcast September 15, 2015 at 10:00 am Pacific Time / 1:00 pm Eastern Time)
During this live virtual event, Cisco subject matter expert Vinit Jain provides us with an overview of Multiprotocol Label Switching (MPLS) virtual private network (VPN). MPLS VPN is a cost-effective solution that provides backbone connectivity and other related services to end customers without compromising customer privacy. Because MPLS provides protocol-independent forwarding, MPLS VPN can be implemented to utilize the existing MPLS infrastructure to provide the service. Ever since RFC4364, many service providers now offer VPN services to their customers, using a technique in which customer edge routers are routing peers of provider edge routers. The Multiprotocol Border Gateway Protocol (MP-BGP) is used to distribute customers’ routes across the providers’ IP backbone network, and MPLS is used to tunnel customer packets across the providers’ backbone.
MPLS VPN overview
Basic MPLS VPN configuration
Live troubleshooting demo
Vinit Jain is a technical lead with the High-Touch Technical Support (HTTS) team supporting customers in areas of routing, MPLS, TE, IPv6, and multicast. He also supports a wide variety of platform issues such as high CPU; memory leaks; Cisco IOS, IOS XE, and IOS XR Software; and NxOS code base. He has delivered training within Cisco on various technologies as well as platform troubleshooting topics. He has also written a workbook about Cisco IOS XR Software fundamentals on the Cisco Support Community. Vinit holds CCIE certification (no. 22854) in R&S, Service Provider, and Security, as well as multiple certifications on programming and databases.
We look forward to your participation. This event is open to all, including partners. Please Share this event in your social channels. You have a chance to win a prize by filling out the survey after attending the live event.
Have a technical question? Get answers before opening a TAC case by visiting the Cisco Support Community.
Hi Friends, I have an ASR 1001(Cisco IOS XE Software, Version 03.16.01a.S/Cisco IOS Software Version 15.5(3)S1a).I checked it, but can't configure 'MPLS ldp', and no MPLS command under the interface. My question is which lowest release can ...
It is established that auto-upgrade should be disabled during an XR upgrade process. However, what is recommended for normal operations? I can see the advantage of having "auto-upgrade" in place so that any RMA or new LC's would/should be upgra...
Hi Everyone, I'd like to know what is most MPLS providers' SOP for their COS especially for Premium i.e. Voice. If you subscribed 10M Premium and exceed that amount, what happens? Assuming the the entire pipe purchased is 100Mb for argument sake and ...
TRAI Regulation on Inbound outbound calling in Domestic Call centres in India As govt of India is promoting to create jobs in rural area's in Big way we are getting stuck as there is no clarity of making or receiving calls in our centers in Rural Are...
Hi, I'd like to ask how to check via SNMP signal to noise ratio or number of codewords (without errors, with correctable errors etc.) on interfaces connected to CTMS via R-PHY shelf. So far, I've been using OIDs from DOCS-IF-MIB (like for exampl...