This session provides an overview of the ASR 9000 Series routers and the different ASR 9000 platforms, as well as an introduction to the configuration of the Cisco IOS® XR CLI and routing protocols. The ASR Series routers are the cornerstone for modern carrier networks. They are designed to grow networks in accordance to your business needs as a modular, high density, power efficient, and secure platform with software virtualization capabilities. The session includes a live demonstration of the ASR 9000 Series routers and the best configuration practices.
Elvin Arias Soto is a Customer Support Engineer on the Cisco IOS XR Team in Cisco’s Global Technical Assistance Center (TAC). He has experience across different technologies such as OSPF, BGP, IS-IS, EIGRP, Cisco IOS XR, DMVPN, MPLS, and Multicast among others. Elvin holds a Bachelor’s Degree in Information Technology from the Iberoamericana University of the Dominican Republic. He has several Cisco Certifications, such as CCIE R&S #57406, CCNP R&S, CCNA Service Provider, and CCNA Security. He is currently preparing for the CCNP Service Provider. In addition, the Cisco Learning Network community has selected him as a Cisco Designated VIP for 5 years in a row (since 2013).
Dears, I have ASR 9K with RSP board type of (A9K-RSP880-SE) and GPS ports (1PPS, 10MHz and RS232) are connected to the RSP board but the GPS light in the RSP isn't turning up. Your suggestion is highly appricated. Regards
Hi, I have a problem in my small PBB-EVPN lab installation.Two PE routers (ASR9904) are directly connected via a 100GE link. On these two routers, a full and correct operating PBB-EVPN configuration is implemented.The ingress ports on the access side...
Hello everyone,We're having a little issue which we've been struggling with over the past few days.We have a PE with a LACP L2 bundle-ethernet interface comprised of two GigabitEthernet physical interfaces, which are facing customer equipment. We provide ...
Hi, am faced with a rather weird one. I have configured a L2VPN between a pair of NCS5501`s, and connected end devices(CPEs) to the attached VLAN. All is working, except connectivity to a BVI interface configured on on one of the routers, from the remote ...