Please join Cisco at OFC 2014 in San Francisco March 9-13 where we’ll demonstrate how the Evolved Programmable Network powers the Internet of Everything through innovations in programmability, convergence, and scale. The recently announced Network Convergence System – the first product family built from the ground up around convergence – will be front and center, with live demonstrations of the NCS 6000, NCS 4000, and NCS 2000 series products.
The Cisco Network Convergence System
Massive scale of packet based services and high density optical interfaces will be on display as part of the NCS 6000 demonstration, while the NCS 4000 will feature convergence of packet, TDM, and optical services with multi-chassis scalability. The NCS 2000 will show superchannel creation and transport over a flexible DWDM architecture built upon the industry’s most scalable flex spectrum ROADM.
Last year’s unveiling of the Cisco CPAK module was undoubtedly the highlight of OFC 2013. This year we’ll focus on CPAK’s ability to address a variety of applications from data center switching to routing and transport, highlighted with a live demonstration of the industry’s highest density 10G single module transceiver, the Cisco CPAK-10X10G-LR.
Last but not least, Cisco’s booth will feature a multi-layer SDN technology demonstration featuring 3D visualization of constraint based service activation.
Cisco experts will be onsite to discuss the Network Convergence System, the CPAK portfolio, and to provide previews of some exciting upcoming products. Please contact your Cisco Account Team to discuss further.
We look forward to seeing you at Booth 4359 in the Moscone Center at OFC 2014.
Watch a video of Ron Johnson, Director of Architecture and Technology at Cisco, inviting you to OFC 2014. Watch the video here.
Hi, I'd like to ask how to check via SNMP signal to noise ratio or number of codewords (without errors, with correctable errors etc.) on interfaces connected to CTMS via R-PHY shelf. So far, I've been using OIDs from DOCS-IF-MIB (like for exampl...
Hello! I have several IOS-XR routers and have been monitoring them with SNMPv3 for quite some time. We have them configured with an OSPF underlay with LDP, and then use L3VPNs/VRFs for public internet interfaces. I am running into a problem using SNM...
Hello,How can I verify status of license (Ten Gigabit Interfaces) loaded on secondary (standby) pre 5 procesor on my ubr 10k platform?Command show licence display info about primary processor:Index 1 Feature: WAN_LicensePeriod left: Life timeLicense Type:...
Hello,( R1 ) -ibgp-> ( R2 ) -ebgp-> ( R3 )The scenario is that router R1 is announcing routes to R2. Those routes are tagged from R2 inbound using RPL (community is 123:123). Now the R2 has an RPL policy towards R3 which dictates to match any r...
Hi All, I have an ASR 9000, but it doesn't support MPLS. The current release is 4.2.1, and if is it possible for me to upgrade it to 4.3.4? When I login with my CCO account, I found the software is 4.3.4(MD), and why it has an MD? Thanks,Mei&nbs...