100% CPU usage. RV180W Firmware Version 1.0.2.6

[bartlingja]

Since I updated to Firmware Version 1.0.2.6 cpu usage shows 100% with no sing of lowering.

So since 2 days now its always runngin at full speeds for no reason.

Firmware Update, Factory Reset, Setup as before. => 100% CPU

Is this a common problem? Is there any fix for that? Or at least a way to get informations what causes this?

Kind reagards

bartlingja

[bartlingja]

Hey Luis,

old firmware is not an option because some day wan stops working and cant be reactivated for no reason...

so i am looking forward for a new fixed version, but as long as its just a ui bug .. its ok the way it is..

regards

Jan

[asilverhawk]

Dear All.

I had the same issue and it got resolved after I downgraded to 1.0.1.9 firmware.

[andym8674]

Hello,

just so everyone is aware i have had a call logged with Cisco since i bought these devices, i have just received an email stating the high CPU usage issue will infact be resolved in the next Firmware update scheduled for realease at the end of March 2014.

Cisco have confirmed this is a GUI glitch (not refreshing)

Subject: ******** : ESC : RV180w : CPU utilization is always 100%25

Hello Andrew,

The following is the case status update courtesy notice.
This issue you reported remains open with our engineering and development team.
The issue will be addressed in the next firmware by the end of March

Regards,
Nirali patel
Cisco Systems

hoping the additional Bugs are also addressed as i rather like these devices now. The VPNs have been bullet proof, shame no IPsec support for apple devices tho.