Routers - Small Business

Hi,I've one SRP527 configured and working with one SSID with WPA Personal and TKIP with no problem.After i had the second SSID, no mather what security i choose to it, both the SSID became unsecure.I check the router and both the SSID's are configure...

HelloI have configured my RV180w with several PPTP users and everything was working fine. I have been establishing a VPN connection from my iMac at home to the office where the RV180w sits.I recently had to change my modem/router at home to a Netgear...

Hello,We just installed a new Cisco RV320 Router in our entreprise and we are encountering a lot of problems recently as the number of users are migrating to new infrastructure.Basically the router is connected to a wan interface and served 3 switch ...

Hi, I have a WRVS4400N VPV router and want to connect to it remotely via VPN.The problem is that my internet-provider block almost all ports below 1000.Can I change the port-number of VPN? If so, how?I have a cable router that I configured so that WR...

Hi i have a RV 042 and RV 120 W . it is working fine when i use both end RV 120 W but when i replaced one side with RV 042 the tunnel is not coming UP?Is there any compatibility issue with RV 042 and RV 120 W?? Can eney one help me this issue.. Thank...

HelloI have a Cisco RV180w in my office which is great but I am struggling to connect from my Netgear D6200 using VPN PPTP. If I have to replace my D6200 modem/router is there a good Cisco model available?

I need help re-Cisco 2921 router...which I believe I messed up....initially, I couldn't login to the router after changing the initial password but I managed to get that working. I can go to # mode now.some how, I copied startup-config to running-con...

I use a RV042 VPN router as the primary internet gateway for my small business. I have enabled PPTP access so I can tap into my office network remotely. It all works extremely well ** EXCEPT ** that the router drops the PPTP connection every 30 minut...

Hi Everybody, Want to have on Cisco RV320 Both links ACTIVE i.e UP but traffic should pass through Priority Set links i.e if Primary is up traffic should pass through it and when it goes down, it should pass through secondary link.This requirement we...

I am unable to block ports using access rules. Here is an example of a rule. I have set up blocks for all IP's, only the second IP, block SSH, block SSH-TCP, and block SSH-UPD. Port is still open. I even rebooted the device.  

Greetings,I have been trying to configure a local DMZ on our network with the Cisco Small Business RV220W router, running the latest 1.0.3.5 firmware but it doesn't seem to be fully functional? Does the DMZ feature actually do anything at the current...

Hello,I have 2 IP's on two different wan-ports. No i want to expose one machine from my LAN to the internet, on port 80 to do everything else with a reverse proxy. The other ip however must forward traffic from port 80 to a different machine: <91.x.x...

Hello guys! I want to know Can we separate video streaming on RV-082 router?For example I route all HTTP traffic to one WAN link but is it possible to separate http video streaming from it to the 2nd WAN link?

Hello all,I'd like to share with others one tricky topic on product RV120W (btw very fine pce of hw). When I did initial setup, I went trough the documentation precisely. I set up 2 VLAN and 2 WiFi (one as main and other for guests). When I got to wi...

The site-to-site VPN between two RV110W never worked well.The VPN connection is always drooping and it is always necessary to manually click the 'Reconnect' button at the 'IPSec Connection Status' page to reconnect ... and it always reconnects.Also t...