Routers - Small Business

Conversation started today8:55pmRohit Saurav Hi ,My Egress router 2951 is experiencing 100%  high cpu utilization periodically , leading loss of session .can't able to ping the devices and lot more.  The RX and TX load is completly utililzed.Please g...

Good Afternoon,I have a Cisco WRVS4400N router with an active Protect Link license.  I recently began having an issue where internet access would cease to work.  Upon inspection of the router I noticed that the Protect Link feature was unavailable an...

We currently have a RV042 v3 with two Internet Connections. T1 and DSL. We are setup to use the Primary WAN 1 (DSL) and Backup WAN 2 (T1),  However I want a internal device to be able to only use the Backup WAN such as for RDP for remote access. Is t...

Releasing external access to a internal ip using only certain ports by RV042G I need to access the external ip 192.168.0.100 which is a server cameras, but only need access to some ports tcp and udp, eg 100, 3550 and 6550 Where do this redirect? the ...

I have setup portforwarding on the RV220W, to allow outside connections on RDP. I have tested that LAN RDP works fine, but when I test using an outside address trying to connect to an inside windows PC with RDP nothing happens.I was wondering if anyo...

I have 2 RV220W routers connected via VPN and they seem to be working fine. All machines on both sides of the VPN can see each other and network sharing is working fine.Lets call one end SITE A and the other SITE B. When I am on a machine at SITE A a...

Hi there,we want to setup a RV042 router to Cisco 2811 router with two ISP connections.My Question is GRE tunnel is feasible for such a setup?If not on RV042 the backup vpn tunnel is straight forward how it will be setup ...What about 2811 IOS setup?...

HiI have purchased a RV320 small business router for my home office, but i am experiencing massive SYN Flooding attacks when clients connect to my ftp and when rsync backup is performed.My equipment consists ofCisco RV320 Router running v1.1.0.09 (20...

It doesn't look like SNMP is working at all on the RV082 router.  First off, the router has 10 ports, only 9 ports show (We are using WAN1, not WAN2, but WAN2 is not disabled).  The next issue is I am getting statistics for eth0 & eth1 only, and both...

I have been fighting WOL for three days now...https://supportforums.cisco.com/message/4062562Finally it looks like it comes down to enabling "IP directed broadcasts" a.k.a "subnet directed broadcasts" in the firewall.How is this done?thanks,Jon

Hello, after succesfully update to version 1.0.5.6, I have errors in my log.I made a factory reset after update and manualy set everything.I have cable internet connection, DHCP server in Cisco, use wifi and I have a few firewall and forwarding rules...