Routers - Small Business

  Hello, I have an RV082    that runs  VPN from our  building to a remote office ....the connection between the 2 buildings  is DSL ( 7mb )off the RV082  installed at the remote office, we have 7 computers  running Windows RDP sessions  to their desk...

I'm considering upgrading a small business to the newly released RV180 or RV180W.Does the RV180 series support 6rd (IPv6 rapid deployment?).I see 6rd documented in the other small business routers (e.g. RV110), but I can't find it in the RV180 docume...

I'm running FW 1.02.01 (23) and I'm having problems with the DNS proxy.  I have DNS Proxy enabled for my DHCP server on the router and I have my dns server programmed into the global dns location.  I cannot ping any DNS names for my IPSEC VPN tunnel....

I am trying to create a VPN between an SRP547W and a Cisco IOS router, in this case a UC540.I am running firmware 1.2.4 (003) Jan 11 2012Now I can do this with an SRP527W and many other routers successfully. Including other IOS routers 1801, 1941 etc...

Hi all,I've setup an RV042 at our office and have created a VPN to allow mobile workers to connect to our internal network.  We have a vendor who needs to ssh into an internal server, but I'm having trouble getting this set up.  The documentation sug...

raiserror and xp_sprintf have in the past been liable to overrrun attacks.But blocking my use of them OUTGOING means I can't manage or maintain any stored procedures that use these keywords, which means I can't manage our databases AT ALL.This is a h...

I am deploying a small wireless LAN (192.168.1.xxx) at a remote site and would like to access a PC at LAN IP address 192.168.1.2 across the Internet via TeamViewer so as to monitor devices on that LAN.  The wireless LAN uses about 12 Cisco Aironet 13...

Good morning,I purchased a RV042 V03 router with firmware version 4.1.1.01-sp (Dec 6 2011 20:03:18) and I need to create a VPN connection through a remote client. I added a new tunnel in the "Client to Gateway" section, so I created a VPN client acce...

I have tired different repeaters. First the WAP4410N. Especially in WDS mode it locks the router up. I have to restart it.Out of desperation I bought RE1000 that says it works with any "N" device. It also locked up after successfully configuring it.N...

http://www.smallnetbuilder.com/security/security-reviews/31746-cisco-rv180-vpn-router-reviewed

Hi,I'm trying to move from a faulty SRP527 to SRP 547 - I tried a Restore from Backup, but it doesn't work.So start from fresh, and I'm having an issue trying to add a 2nd SSID to a VLAN...I keep getting the error:"FAILED! SSID 2 has joined another V...

We are looking at purchasing and RV042 soon and have one cruitcial question. I am looking at having two internet connections running into the RV042. The only load balancing is going to be that all the VOIP traffic will go through one connection (eg W...

I have a RV082 that has an issue keeping an IPSEC Gateway to Gateway VPN running from itself to our ASA 5510.At 8 hours of connectivity (I can almost set a clock to it) the Tunnel will say it is connected on the RV082 but on the ASA 5510 the tunnel i...

Hi, I have activated Protectlink Web. The service is excellent im very pleased about it. But today i started to get "router is busy"  in all pages, so we restarted the router. That problem was solved but now the the web Protection is no longer workin...

Hi, I have activated Protectlink Web. The service is excellent im very pleased about it. But today i started to get "router is busy"  in all pages, so we restarted the router. That problem was solved but now the the web Protection is no longer workin...