Routers - Small Business

Hi,I recently ( three days ago ) purchased a SRP 527w and have been using it in a mixed Mac/Windows network. The setup is currently primarily using defaults apart from enabling logging. While I was still able to access the internet with some applicat...

Hi there,i got another (see open discussion about logs) issue:there is a linux box where i run an eggdrop bot and normally you do a Direct Client to Client CHAT (DCC) to administer it... now i had the same configuration by at least 2 years now and ne...

Hello there, this is not just a vent, i would like to find some answers..so1) Why RVS4000 is called a "Cisco" small business router when it does NOT run IOS? Why isn't it called a "Linksys" router? People may get confused, you know..2) Why there is n...

I am trying to set up a SOHO office web server. The server is directly connected to my CISCO 877M router. I am trying to use CISCO Configuration Professional 2.5 or CISCO Configuration Assistant to configure the router but have run into problems and ...

Hi our business was looking at purchasing one of these Cisco routers and were curious if it supported WPA2 EAP-TLS?

I have a problem with QuickVPN on RVS 4000.When pc 1 is connected with QuickVPN using profile 1 (bes1), then pc2 with profile 2 (bes2) is being disconnected.Pc1 and pc2 is both using win7.Here is some logAug 8 08:35:10 - [VPN Log]: "best1_rw_rw" #14:...

Hi,I have a RVS4000 at one location and a second RVS4000 at home.  I have established an IPSec VPN tunnel between them and it is UP.  I can ping the routers from each end no problem.  I can ping  the IPs listed in the "Local Group Setup" and the "Rem...

Hi Friends,I was wondering if you can help me with a issue that I have;I have setup a VPN connection for some of the guys to work on a remote site, I have the VPN configured up and running but have an issue with DHCP lease that it is recieving from t...

Hello All,This is my first post, I hope it makes sense.Before purchasing the SG300-MP my 871w and Power connect 2716 worked well togetherNow I’m try to uplink my sg300-mp to my power connect 2716 with no success. I’ve assigned an ip address to inter ...

Greetings,I am setting up a dual WAN network in our small business office and I am confussed on the set up of the RV042.On WAN1 I have a satellite modem connected On WAN2 I have a cradlepoint CTR35 Router with a verizon aircardThe satellite has lag i...

Hi all,Can I please ask if anyone knows of how to filter traffic between VLANs on the RV220W? I cannot seem to see a way.I only have two VLANs. The main VLAN and a seperate VLAN for guest WiFi access. I have inter-VLAN routing disabled on the guest V...

Right out of the box, the WRVS4400N [firmware v2.0.1.3] I just purchased says the WAN interface is DOWN; and it simply will not obtain an IP address from the Arris TM602G cable modem it is attached to. Internet still runs great on the old WRT54G. Is...

Hi, first time here to me.Recently i bought a Cisco RVS4000, upgraded the firmware to latest stable release (Firmware Version: V2.0.2.7) and started configuring it.Yesterday i found out that as the dsl connection drops (i'm using PPPoE with an ethern...

I have established a static route from outside on port 22 (SSH) to a specific network server. However, when I attempt to address this port from inside the network, the SR520-FE-K9 still intercepts TCP port 22 requests.How do you reassign the SR520 to...