Routers - Small Business

Hi Guy's Is it possible to connect to routers back to back,R1 has physical interface with ip address.R2 has a subinterface configured with IP addressI can not ping the IP of R2 from R1, if I move the ip to the physical interface on R2 I can ping both...

Hi,I have an RV340w configured to talk to a VDSL modem that is in bridge mode via PPPoE. Both the IPv4 and IPv6 connectivity uses the shared PPPoE credentials and receives an IPv4 address (29 bit subnet) and IPv6 addresses - an ND prefix (64 bits) an...

It took me several hours to find out how to restore a configuration on a second RV340 or a RV340 after reset to factory defaults and I don't know why it is so confusing and complicated.When I restore the configuration from PC I receive a "Network_Err...

Hi Got a really strange issue with an RV340.  Setup was originally with a 4G mobile router from the LAN port to WAN1 and an ADSL line/modem on WAN2.  There’s 4 VLANS setup and everything works normally and as expected with inter vlan routing, WAN fai...

HiRegardless how I'm setting up the automatic updates (check never, check every week or check every month), my RV345 keeps on checking available updates and applies them and restarts, impacting my work by loosing the internet connection for some minu...

I have RV042 10/100 4-Port VPN Router and I have set up dual WAN to Smart Link Backup and WAN1 as primary. WAN1 Configuration Details:Upstream : 12500 Kbit/SecDownstream: 12500 Kbit/SecEnable Network Service Detection : CheckedRetry count : 5Retry ti...

When upgrading to 1000 Mbit/s internet connection I bought the RV320.My setup:RV320 - Firmware 1.1.1.9Working mode: GatewayFixed IP from ISP via DHCPDMZ enabled 10.7.7.1 (10.7.7.0/24)When I enabled the DMZ, the RV320 wrote new access rules on the fly...

Hi:I have an RV345 router.  I purchased the Security-License for this to do Web Filtering.I was able to purchase the license, load the license and turn on web filtering.  Almost every month, the web filtering is turned off (my users notice that they ...

Hi all, For my TV box (Telenet digicorder) to work interactive; it must be directly connected to the Telenet modem (modem only) so it can be detected by Telenet.The prescribed method uses a switch after the modem to connect router and TV-box separatl...

Hello, my RV345P can't connect to my mailserver in the DMZ: 2020-12-09T07:57:14+01:00 <info>kernel: [48238.250542] FIREWALL: DROP PACKET is not associated with an existing connectionsIN=eth3.1 OUT=eth3.4094 DST_MAC=10:f9:20:13:97:3d SRC_MAC=:ac:87:a3...

Hello ,  i recently purchased Cisco RV340 and my current Firmware Version: 1.0.03.20 , i have configured ssl vpn with local users and able to connect with out any issues, i have an Active Directory and when i am trying to configure with my AD it was ...

Hi, I will soon be swapping out a Cisco IE3000 switch with 8 ports for a switch with 24 ports. I am hoping to keep the existing configuration of the switch but then just add some configuration against some of the other ports that we will be using for...

Hello, I got my RV345P today but I can't get the DMZ setup for my mailserver to work (as it did with my Linksys LRT214). Setup:1) ISP modem with 80.x.y.z provider IP where my mailserver IP 212.x.y.z is routed to2) Synology DiskStation LAN1 with mails...