Routers - Small Business

Hi,I have a Linksys RV042 routher, with 100 Mbps (WAN) off service. However, when a speed test is conducted, it only manage 50Mbps. WHY? What is the maximum speed?

Thanks to this community, I've understand that the FXO line of an SRP52x is a "life line" only. This is OK for me, it's exactly what I'm lookin for:I want to use a SIP number for outside calls and be able to make and receive calls even when power is ...

Router has latest firmware.  WAN1 connected, WAN2 not connectedRDP 3389 & 3390 are forwarded and functioning correctly.  Port 8080 functions correctly when configured for Remote Management.  I have Port 8081 functioning as Remote Management currently...

I am trying to set up a configuration that will accept QuickVPN users with an RV082 that is tunneled to another remote network.  The QuickVPN users need access to IP's on the remote network.  Essentially:Ad-Hoc Users <- QuickVPN Tunnels -> RV082 (192...

I am not an IT manager, but I am trying to set up an additional route through our router for RDP using NAT. I have successfully set up two other workstations doing this, but the third is not working. I set the first two up by forwarding the public IP...

Hi,Can anyone tell me how to add an additional IP addresses to the WAN interface on a SRP527W.We are connecting to an ISP which assigns us a static IP address with our ADSL account. We also have another 2 additional WAN IP addresses that we have purc...

HiDoes anybody know if SRP527W supports 802.1Q VLAN tagging on DSL WAN connection for RFC1483 bridged connections?ThanksJustin

Hi!I have here a RV120W that's behaving quite oddly. From a normal router point of view everything is OK (wired and wireless LAN works, I can access internet, etc.).Problems started when I wanted to set up port forwarding - requests from the WAN side...

I have brought new rv016 with 3.0.0.19tmand I use 4 adsl linesProblem I found in this version is :1. when I configure bandwidth manager to choose which line each port will be outmy speed down to 400kbp/s only (but when disable(delete all setting) my ...

I had install SRP527W Router in our office yesterday (new)No problem during initial setup - internet, wifi, wlan - OK! Several computersconnected through WiFi, few through cable (switch). No problem with routerduring working day and all computers wer...

Bought a Cisco RVL200 (latest firmware included - I checked),  and I've set it up to serve as the gateway/firewall for my home network.  I also intend to use the VPN functionality when travelling as well as  serving up content from a web server behin...

I'm trying to get a site-to-site VPN established from a 527w with a dynamic IP address to a WatchGuard, and that fails at phase 1.I'm using Main mode and dyndns, which the 527w reports as updated successfully, but the WatchGuard diagnostics say the 5...

I have Rv042 so I need it to make load balancing for 2 ADSL lines.The 2 ADSL modems working as a router (not bridge) so I connect ADSL1 (adsl router) to Internet1 in RV042 and ADSL2 to internet2/DMZ .In the RV042 configuration I make WAN1 and WAN to ...

I have a 3g verizon WAN connection via a 3G DigiRouter that is functioning in pass-through mode. Behind that, I have the RVS4000 router. I am unable to connect via the VPN using the QVPN client.I have been able to change the remote managment ports on...