cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

Welcome to the Cisco Small Business Community

Have a question? Click on a topic board below to get started in the community.

490
Views
0
Helpful
3
Replies
kevin crick
Beginner

Can SRP500 be used in DMVPN

I would like to use a SRP500 series router in a DMVPN solution. Or perhaps there is another scalable VPN solution I could use?

Sent from Cisco Technical Support iPhone App

2 ACCEPTED SOLUTIONS

Accepted Solutions
Tom Watts
Advocate

Hi kevin, dmvpn relies on cef and routing protocols such as eigrp, ospf, etc. The small business products support only ieee standards, excluding cdp.

-Tom Please mark answered for helpful posts http://blogs.cisco.com/smallbusiness/

View solution in original post

Hi Kevin,

That is correct - the SRP only supports point to point VPNs (connecting to a 2811 works).

For DMVPN, you will need a IOS router.

Regards,

Andy

View solution in original post

3 REPLIES 3
Tom Watts
Advocate

Hi kevin, dmvpn relies on cef and routing protocols such as eigrp, ospf, etc. The small business products support only ieee standards, excluding cdp.

-Tom Please mark answered for helpful posts http://blogs.cisco.com/smallbusiness/

View solution in original post

Hi Thomas

Would the only option then be a site to site VPN built between the HUB (2811 Router) and each spoke? The config would get messy as the number of Hubs increased.

Sent from Cisco Technical Support iPhone App

Hi Kevin,

That is correct - the SRP only supports point to point VPNs (connecting to a 2811 works).

For DMVPN, you will need a IOS router.

Regards,

Andy

View solution in original post