08-13-2018 12:01 PM
This router was updated some time ago. Since that time access to the gui has failed. I tried factory reset and I believe something occurred but not sure what as I still can't gain access.
I tried from the wan side also, no joy.
What I think happened is a bug in the software or even a possible hack, but I doubt that.
I do have a backup on usb but I can't do anything without access to the gui.
I wish I could access the cli, but I believe ssh is blocked. port scan showed only a single port open. I believe 1723.
08-13-2018 05:39 PM - edited 08-13-2018 11:46 PM
Are you getting a certificate error? Continue to the site any way. It should work.
Sorry just noticed you can't do a factory reset.
08-14-2018 10:46 AM
Thanks for replying Lee,
I know of that certificate issue.
But not getting a factory reset tops the issues. If I could get into the GUI I think I could get around things. I am convinced it is the upgrade that caused this.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: