I purchased a Cisco 1941 (Used) to replace my failed RVS4000 Router. (Home office network)
I setup everything to the point where I want to attempt to access the Web GUI and setup further (Preference)
Yes, I know use of the GUI is frowned upon but I am not bothered by it.
I assigned the GE0/0 Interface a static ip and all that, Also enabled HTTP using the ip http commands
I get to the webpage and enter the user name and password, and I get a white page which shows me nothing.
I want to configure internet settings, configure what ports to use for internet LAN and all the regular stuff for remote access which I would like to do with the GUI. I am not finding much online to get this going. Thanks!
Installing and Activating Service on the Cisco DNAC Appliance v1.2.8
This document describes the steps that you need to follow to install and activate the Cisco Digital Network Architecture v1.2.8
Note: For additional information about how to use the Cis...
Hey Everybody, Corey here with another issue of our newsletter. Where you can keep up with the latest from our community and support teams.
Happy September all!
We've got lots of new videos to share this month including for the n...
Dear,we have IP cameras thath only support 100Mb SFP slot.Model cameras SiQura BC920https://siqura.com/product/bc920/Now we need Cisco switch with 24 SFP modules thath still support 100Mb SFP.Which CISCO network switch still support 100Mb ?Model C930...
Pack your binoculars and mosquito repellent, and join us at SpiceWorld 2020, September 15-17. Escape from the IT jungle with a visit to our virtual booth to get resources to plan your journey, or chat with a Cisco "guide." Attend one of our breakout sess...
Escape the IT jungle with a visit to our virtual booth at this annual event. Get resources to plan your journey, or chat with a Cisco “guide.” Attend one of our breakout sessions, and try your luck at our Connect Small game.
Register for free!