I purchased a Cisco 1941 (Used) to replace my failed RVS4000 Router. (Home office network)
I setup everything to the point where I want to attempt to access the Web GUI and setup further (Preference)
Yes, I know use of the GUI is frowned upon but I am not bothered by it.
I assigned the GE0/0 Interface a static ip and all that, Also enabled HTTP using the ip http commands
I get to the webpage and enter the user name and password, and I get a white page which shows me nothing.
I want to configure internet settings, configure what ports to use for internet LAN and all the regular stuff for remote access which I would like to do with the GUI.
I am not finding much online to get this going.
Thanks!
Dillon
