Hello, I am trying to bind an IP & MAC address. I successfully set up 5 of these bindings, but on the 6th I miss-typed the MAC address. I deleted the bad entry. Now when I try and re-enter the IP address in the table, it gives me a red error message at the top of the table that says "IP Already in the list!". See the attached screen shot for the exact error message display. It does not say what list. I rebooted the router several times to clear the ARP table.
What list is it referring to and how do I clear it?
QuestionDear All,I'm currently looking for firmware version 220.127.116.11 for Linksys SPA400 Analog Telephony Gateway. Unfortunately, my device was bricked and I was able to recover it using a recovery tool and recovery firmware version 18.104.22.168 but can't find v...
Change in ASD Automatic Software Download Feature
Dec 13th, 2019
Cisco RV160, 260, 340, and 345 Series Routers
Due to an API change in Cisco’s software download platform the Automatic Download Feature (ASD) on RV series routers will be temporarily ...
SFP Module Support List for RV160x and RV260x Devices
Small form-factor pluggable (SFP) ports are included on the RV160 and 260 routers to allow the use of optical SFP transceiver modules. SFP’s convert the optical signals to electrical signals. SFP’s al...
Welcome and thanks for visiting the Small Business Community Newsletter. This is our first of what we will make a monthly newsletter where you will be provided information on New products and trends, What’s ...