Hello,
Hopefully someone may have experience with this.
We have a number of Cisco SG300 switches to build and have been looking into using the auto install process to automatically update firmware and perhaps install some template configuration.
After looking at the guide book, except mentioning the DHCP options to use and some basic details, there is not much detail. I have tried to get this working via a Cisco router DHCP server setting the necessary options but have not had much success. Experience has told me that I could "rat hole" for a few days on this and still not have a working solution hence this question.
Has anyone managed to get this working and if so could you supply any details on the actual DHCP options used and the exact DHCP option format that you used ( Ascii, IP, Hex etc ) and on what DHCP server.
Thanks in advance.
Regards,
Robert
