cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

Get the latest Cisco news in this December issue of the Cisco Small Business Monthly Newsletter

727
Views
0
Helpful
2
Replies
Highlighted
Beginner

Cisco SRP527W-U functionality question

Hi There, I have a configuration question in regards to the Cisco SRP527W-U.

We would like to configure it in the following way, 1) we have an ethernet termination for the WAN 2) we have 2 different vlans going to 2 different switches.

Can we have the default gateway for 2 LAN subnets and a default route via a /30 for our WAN. Can we use the 4 switchports for this?

switchport 1 VLAN 2 (Switch 1 LAN)

switchport 2 VLAN 3 (Switch 2 LAN)

switchport 3 VLAN 4 (Link to Data centre switch with /30)

Regards,

Scott

Everyone's tags (4)
1 ACCEPTED SOLUTION

Accepted Solutions

Cisco SRP527W-U functionality question

Hi Scott Brien

This model will function as a Layer 3 router, you can route vlan's and do static routing, and other functions as

Static routing

Routing Information Protocol (RIP) versions 1 and 2

Generic routing encapsulation (GRE)

Point-to-Point Tunneling Protocol (PPTP) -- supported on primary WAN interface

Layer 2 Tunneling Protocol (L2TP) -- supported on primary WAN interface

Policy-based routing

So, You can  have the default gateway for your 2 LAN subnets and a default route via a /30 for your WAN

If this answer was satisfactory for you, please mark the question as Answered.

Thank you

Greetings, Johnnatan Rodriguez Miranda

View solution in original post

2 REPLIES 2

Cisco SRP527W-U functionality question

Hi Scott.

Yes, this is a valid configuration, you could use 4 switchports.
Set the serial interface that goes to the switch that contains the vlans as a default gateway.
and set the ethernet termination that goes to the Wan as the default route.
In that way the vlans will have access to the wan.

Cisco SRP527W-U functionality question

Hi Scott Brien

This model will function as a Layer 3 router, you can route vlan's and do static routing, and other functions as

Static routing

Routing Information Protocol (RIP) versions 1 and 2

Generic routing encapsulation (GRE)

Point-to-Point Tunneling Protocol (PPTP) -- supported on primary WAN interface

Layer 2 Tunneling Protocol (L2TP) -- supported on primary WAN interface

Policy-based routing

So, You can  have the default gateway for your 2 LAN subnets and a default route via a /30 for your WAN

If this answer was satisfactory for you, please mark the question as Answered.

Thank you

Greetings, Johnnatan Rodriguez Miranda

View solution in original post